欧美专区亚洲I日本中文字幕久久I亚洲精品2I懂色av蜜臀av粉嫩avI人妻熟女aⅴ一区二区三区汇编I国产亚洲成人avI欧美午夜aaaaaa免费视频I日韩欧美中文字幕在线观看I91av免费看I日韩岛国片I亚洲成a人片77777精品I国产成人a亚洲精v品无码I成年人免费观看网站I91官网在线I狠狠天天I久久久久九九九I7777奇米四色眼影国产馆Ihd性videos意大利精品I亚洲av无码成人精品区I免费成人电影在线观看I欧美午夜精品久久久久久蜜I精品一区二区三区免费看I可以免费看的黄色I免费三级黄色Iwww.精品久久I香蕉成人网I91久久精品无码一区二区

DONDE SEAL

CHINA

Professional Of Mechanical Packing & Industrial Gasket

How to Cut Gasket Material?

Clean radius and straight cuts are achievable on gasket material with the proper tooling. Thinner types of gasket material require nothing more than sharp blades and hollow gasket cutters. Gasket material over 1/4-inch thick require specialized mechanical tools to create the precision cuts necessary to seal a piece of equipment and is best left to professionals. Properly securing the gasket material and ensuring the tools used are in good condition will allow you to cut thinner gasket material efficiently and precisely.

Difficulty: Moderately Easy

Instructions

Things You'll Need:

• 1/4-inch plywood

• Steel rule

• Paint marker

• Utility knife

• Circle gasket cutter

• Hollow gasket cutter set

• Dead-blow mallet

1.   Set the 1/4-inch plywood on a firm flat surface. Place the gasket material on top of the plywood. Using gasket cutting tools without plywood will cause damage to vital tool components.

2.     Measure and mark a rectangle sized to the length and width of the final gasket size with a steel rule and paint marker. Do not use a permanent marker on rubber-based gasket material.

3.     Cut along the marked lines with a utility knife, using the straight edge as a guide.

4.     Mark the center of the rubber gasket material for a round gasket or mark holes needed for fasteners on rectangle gaskets with a paint marker.

5.     Set the center pin of the circle gasket cutter on the center mark of the gasket material. Loosen the thumb screw located on the side of the cutter. Slide the cutting blade(s) to the edge of the cut gasket material. Tighten the thumbscrew. While applying light pressure toward the surface of the gasket material, spin the cutter in a clockwise direction to cut the circle gasket. Adjust the cutting blades as described to cut and remove the inner section of the round gasket.

6.      Align the hollow gasket cutter from the cutter set that matches the size of the hole required in the gasket material. Strike the back of the hollow gasket cutter hard with a dead-blow mallet. Pull the hollow gasket cutter from the surface of the material. If the hole plug does not come out with the hollow gasket cutter, realign the cutter blade with the scored hole and repeat the process until the plug removes from the gasket material. Repeat the process to cut all hole locations in the gasket material.>>The End